QSC DSP-3' Manual descarregar pdf (Página 12)

Section 2: Installation- Basics and Mounting

UNPACKING

There are no special unpacking precautions for the DSP-3. However, it is recommended that you keep the original packing material for reuse

in the rare event that service be required for your DSP-3. If service is required and the original packing material is not available, insure that

the DSP-3 is adequately protected for shipment (strong box of appropriate size , sufficient packing material).

WHAT IS INCLUDED IN THE CARTON:

Item Description Quantity

1- DSP-3 Digital Signal Processor 1

2- 3-pin terminal block connector plug 4

3- #4-40 machine screw, 1.125” long 2

4- #8-32 machine screw, 0.312” long 1

5- Hardware Manual (this document) 1

DIRECT MOUNTING THE DSP-3 TO 2-CH, 2-RU QSC DATAPORT EQUIPPED AMPLIFIERS (CX, DCA, Powerlight2)

The DSP-3 mounts directly to the rear of 2-channel, 2-RU, DataPort equipped QSC amplifiers.

1- Configure the amplifiers DIP switches (QSC amplifiers where the DSP-3 covers the configuration switches) as follows:

•All filters off •Clip limiter off •Mode set as required

2- Align the DataPort plug on the back of the DSP-3 with the DataPort jack on the back of the amplifier and gently push the DSP-3 to seat

the connector.

3- Install the two #4-40 screws to secure the left side of the DSP-3 to the amplifier. These two long screws pass through the DSP-3 and

thread into the inserts on the DataPort (HD15) jack. (see below).

4- Install the one #8-32 screw to secure the right side (as view from the rear) of the DSP-3 to the amplifier (see below).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Sem comentários

QSC DSP-3' Manual Página 12