QSC DSP-3' Manual descarregar pdf (Página 17)

Section 2: Installation- Software Installation & BETA Release Warning

These instruction apply to the June, 2000 BETA release of the Signal Manager application.

Software Installation-

1. Insert the CD labeled QSC DSP-3 Signal Manager into your CD drive (typically drive “D:”).

2. Run D:\Setup.exe and follow the instructions displayed.

3. When the installation is complete, you will be presented with a screen that asks you to view the “Readme” file. Please

take time to read this- it contains important information on how to use the software.

4. After installation, you should have an icon on your desk top labeled “Signal Manager”. Use this icon to start the application.

5. Using the main menu bar at the top of the window, choose the “Help” item and read the Introduction section.

6. IMPORTANT NOTE! The DSP-3 is shipped with all of its pre-sets configured to pass full-range audio signals through both

channels, unless the external contact closure is in the closed position (in which case the output of the DSP-3 is muted).

THIS MAY NOT BE APPROPRIATE FOR YOUR SETUP! BE sure to configure any necessary crossovers , filters,

etc. prior to applying audio signals to the inputs. Damage to equipment may result if these recommendations

are not followed.

7. Please refer to the “Readme.txt” file for information on how to provide your feedback on this BETA release product to QSC

Audio Products.

OVERALL NOTES AND WARNING-

• The BETA RELEASE software supplied with the DSP-3 has not been fully qualified to use in a “show” setting.

• Use caution when making changes to parameters in a “live” configuration. There are some known problems with

undesirable transients when changing filter parameters (especially at low frequencies).

• Certain DSP-object configurations have been observed to cause the DSP-3 to perform an auto-reset. This will result in

muting of the audio and subsequent re-loading of the power-on-default configuration. It is HIGHLY RECOMMENDED that

you establish a power-on-default “preset” that corresponds to your particular equipment setup (such as appropriate

crossover filters, gain settings, input sensitivities ect.). Do this as soon as possible so as to reduce the risk of equipment

damage that could result should an inappropriate DSP configuration be applied. See the release notes in the software’s

“Readme.txt” file for more details.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Sem comentários

QSC DSP-3' Manual Página 17