QSC DSP-3' Manual descarregar pdf (Página 21)

Section 5: Appendix- DataPort Pinout

Pin Signal Description

1 Audio to channel 1 (+)

2 Standby control

3 V

MON

channel 1 plus encode 1

4 I

MON

channel 1 plus encode 2

5 Clip/protect channel 1

6 Hard ground

7 Audio to channel 1 (ground)

8 Audio to channel 2 (ground)

9 +15V from amplifier

10 Data reference ground

11 Audio to channel 2 (+)

12 Amp IDR (model ID)

13 V

MON

channel 2 plus encode 3

14 I

MON

channel 2 plus encode 4

15 Clip/protect channel 2

Description of Encode Signals

encode 1 Bridge mode & power detect

encode 2 Temperature, channel 1

encode 3 Standby mode detect

encode 4 Temperature, channel 2

DATA PORT PINOUT

The diagram below shows the pin assignments used for the HD-15

connectors on the DSP-3 and amplifier.

NOTE!

This information is shown for reference only and is subject to change

without notice as the DataPort feature is specific to QSC products and

not intended for interface to other manufacturer’s equipment.

Note: Powerlight 6.0 and Powerlight 9.0 amplifiers

require that pin #9 be removed from the remote mounting

interconnect cable.

Amplifier damage may result from use of cable that has pin

#9 connections present.

Normal VGA computer monitor cables have pin #9 removed

and are usable. Check before use!

1 2 ... 16 17 18 19 20 21 22 23 24

Comentários a estes Manuais

Sem comentários

QSC DSP-3' Manual Página 21

Comentários a estes Manuais

Manuais e produtos relacionados com Amplificadores áudio QSC DSP-3'